Injection Molded Minnesota Letters - Mounting Options

Injection Molded Minnesota Letters
Installation Methods Available

Plain Mounting

Plain Mount injection molded Minnesota letters are shipped without mounting hardware.

Stud Mounting

Studs are metal threaded posts on the rear of the injection molded Minnesota letters. Specify stud lengths of 1", 1-1/2", 2", 3", 4", 5" and 6". Specify if studs need to be in line for brick or block wall mortar joints. (Brick -- 2-5/8" on center; block -- 8" on center.)

Pad Mounting

Pads are plastic disks on the rear of the injection molded Minnesota letters. Secure the injection molded Minnesota letters to the wall with silicone adhesive. Adjustable or flush pads available upon request. Pad mount only recommended on letters less than 24" tall.

Stud/Pad Combo Mounting

Combinations have pads at the bottom and pad/stud combinations at the top of the injection molded Minnesota letters. Specify if studs need to be in line for brick or block wall mortar joints. (Brick -- 2-5/8" on center; block -- 8" on center.) Not for letters under 6".

Stud/Pad Combo Mounting All

Combination All injection molded Minnesota letters have stud through pads on all mounts. Specify if studs need to be in line for brick or block wall mortar joints. Not for letters under 6".